Every article on this site is written by AI from official sources and checked by a second AI. How it works
Proposed rule

Airworthiness Directives; Airbus SAS Airplanes

Built by the Tribune's code from the Federal Register. No AI wrote this page. Published in the Federal Register Nov. 21, 2025. Document 2025-20572. Updated Nov. 17, 2026.

What it does

The FAA proposes to adopt a new airworthiness directive (AD) for certain Airbus SAS Model A320-251N, -252N, -253N, -271N, -272N, and -273N airplanes. This proposed AD was prompted by a detected deviation to the manufacturing process of the angle fitting connection to side panel skin between certain frames (FR) at a certain stringer on both left hand (LH) and right hand (RH) sides. This proposed AD would require inspecting the fastener holes to ensure they are the nominal diameter, and applicable corrective actions. The FAA is proposing this AD to address the unsafe condition on these products.

The Federal Aviation Administration's summary, as published in the Federal Register.

What it would change

1 part of Title 14 of the Code of Federal Regulations:

14 CFR 39

Before this

499 earlier Federal Register documents under regulation identifier 2120-AA64 since Jan. 1, 2025.

Since then:

What happens next and when

The FAA must receive comments on this proposed AD by January 5, 2026.

The agency's dates, word for word.

Document number2025-20572
ActionNotice of proposed rulemaking (NPRM).
AgenciesTransportation Department; Federal Aviation Administration
PublishedNov. 21, 2025
Comments closeJan. 5, 2026
Regulation identifier (RIN)2120-AA64
DocketFAA-2025-5028

Source: the Federal Register (public domain). The document in the Federal Register